IPB

Welcome Guest ( Log In | Register )

Unbalanced EngineeringSolo PerformanceBlaine Fabrication.comHotpart.comUMI Performance
> Thirdgen parts anyone?
slowTA
post Aug 11 2004, 02:20 PM
Post #1


Experienced Member
***

Group: Advanced Members
Posts: 2,289
Joined: 4-May 04
From: Kenvil, NJ
Member No.: 331



I doubt I'll get much response here, but you never know. All prices are best offer, please send your zip code too. All parts are off of a black '86 Trans Am with grey interior. I either have pictures of everything, or can take them. I don't mind shipping some stuff, but for the larger stuff I would prefer pickup or for you to arange the shipping.

-center console without shift plate or door cover
-black armrests
-computer controlled carb wire harness and computer, has plugs/chip for manual transmission with electric speedometer
-come TPI parts, intake, runners, plenum, throttle body without the IAC housing
-all ground effects except for nose piece and that small section right behind it on the passenger side
-driver's fender, may not fit perfect... car was hit on passenger side and the top of this fender didn't line up right with the driver's door. Something tells me the strut tower was shifted instead of the fender, but I can't be sure
-1 Set of t-tops with bag, rubber isn't in the best shape
-driver side door wtih power window, manual locks, no interior panel
-wrap around spoiler without brake light
-9 bolt rear end with cast iron calipers, 3.2x gears, posi could use some work, needs rubber lines, pads, and rotors... comes with factory master cylinder, combo valve, and parking brake cables
-wiper motor
-blower motor
-washer tank
-guage cluster with either 120 or 85 mph speedometer, I'll check if interested
-dashpad with crack, trying to fix it with a repair kit
-a ton of grey interior plastic pieces
Go to the top of the page
 
+Quote Post
 
Start new topic
Replies (1 - 2)
Dewey316
post Aug 11 2004, 02:50 PM
Post #2


Apex? What apex?
*

Group: Advanced Members
Posts: 245
Joined: 7-January 04
From: Portland, OR
Member No.: 106



I need the trim peice that goes at the rear of the headliner, for a top-car.

97080. Shipping on that may not be worth it though.

(other than that, I can't think of anything I need.)
Go to the top of the page
 
+Quote Post
slowTA
post Aug 11 2004, 06:13 PM
Post #3


Experienced Member
***

Group: Advanced Members
Posts: 2,289
Joined: 4-May 04
From: Kenvil, NJ
Member No.: 331



Dewey, you have mail.

I also have

-36/24mm sway bars, the 24mm might be an option for anyone who relocates their panhard bar?

-tilt steering column, in OK shape, the tilt part isn't sloppy at all, but some of the writing on the turn signal are worn off, set up for cruise if needed
Go to the top of the page
 
+Quote Post
« Next Oldest · Classifieds · Next Newest »
 

Reply to this topicStart new topic
2 User(s) are reading this topic (2 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: 19th May 2025 - 10:21 AM