 35mm Hollow bar bushings |
|
|||||||||
 Apr 12 2004, 10:36 PM
Post
#1
|
|
|
Sponsor  Group: Advanced Members Posts: 1,438 Joined: 24-January 04 From: SoCal Member No.: 152  |
Hey folks, those of you that ordered a 35mm hollow bar from Sam may want to crack the box open and look at the bushings. Apparently Addco shipped some of the bars (one of mine included) with 1 1/4 bushing(s) instead of the 1 3/8" bushings it should have. I thought those of you that were waiting for a rainy day to do the install should check now to be sure you have the correct bushings.
Jason S. |
 |
 
|
 |
Replies
|
Apr 16 2004, 12:13 AM
Post
#2
|
|
|
Seeking round tuits Group: Advanced Members Posts: 5,522 Joined: 24-December 03 From: Kentucky Member No.: 33 |
QUOTE (93RedDevilZ28 @ Apr 15 2004, 06:01 PM) I think I may have the wrong bushings as well. With all of them (and washers) on the endlink bolt, there's not enough bolt to go through the bar and have room to screw the nut on. This thread is about the bushings for the brackets that hold the bar to the chassis, not the endlink bushings. Your problem is "simply" that with the car on jackstands and the wheels drooping (instead of using ramps), the holes the endlinks mount in are not parallel - it's not related to the mount bushing issue. I left a tip in your other thread that may help, though. |
|
|
|
Posts in this topic
Unbalanced Engineering 35mm Hollow bar bushings Apr 12 2004, 10:36 PM
94bird Both of mine say 1 3/8" on them and fit the b... Apr 13 2004, 07:35 PM Unbalanced Engineering So far I am the only one I know of that has had th... Apr 13 2004, 07:41 PM redbird1 How much weight does this bar save you over the so... Apr 13 2004, 09:37 PM Unbalanced Engineering I'm not sure with regard to the 35mm solid, bu... Apr 13 2004, 11:02 PM WOOS1 I didn't have any problems with my install. E... Apr 13 2004, 11:27 PM redbird1 Oh Ya, I ment to say 32mm.
Thanks Apr 13 2004, 11:34 PM ledfoot2 I just ordered one from Sam too. I hope it helps ... Apr 14 2004, 02:48 AM 93RedDevilZ28 Are those measurements in terms of diameter?
I ju... Apr 14 2004, 04:51 AM Bald54 At least you guys got yours. The bars I ordered st... Apr 14 2004, 12:06 PM 94bird It's a bar OD or bushing ID measurement I beli... Apr 14 2004, 10:56 PM 93RedDevilZ28 I think I may have the wrong bushings as well.
Wit... Apr 15 2004, 11:01 PM rscamaro73 Hey Jason...
Might you do me a favor, por favor.... Apr 16 2004, 09:49 AM
94bird Here's a picture I took of my 1LE 32mm vs. the... Apr 17 2004, 01:24 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 5th May 2025 - 06:30 AM |