[atakacs]

I tried to wire my TA for my trailer but I'm stuck. I wired the ground, tail lights, left and right turn signals correctly but I have no idea where to attach the wire for the brakes. On my TA the turn signals and brakes are the same light... just both on constantly instead of one blinking (except for the wing light). Right now, I have tail (running) lights and proper turn signals when not braking but I have no brake lights on my trailer and if I try to turn on a turn signal while braking, the trailer flashes the opposite signal. Do I have to run a wire all the way up to connect to my spoiler's brake light? Can anyone help me out?

<5 wires to vehicle [Draw-tite Module] to trailer & 4-pin attachment>

Thanks,

Andre

This post has been edited by atakacs: Sep 25 2007, 05:31 AM

[atakacs]

An 02 does not have shared lights. ...

Don't forget guys, I have a TA not a camaro... I have nothing amber back there. The honeycombs ARE shared... and that may be my problem. I think I'm trying to use a converter when I don't even need to - I should just be able to straight-wire it. Yikes.

... that converter module I gave you came out of my '99, and was wired into the car over at the left side of the trunk area... No wires were run anywhere else. Of course, I'm not sure if there's a 3rd brake light wire there for some reason?

I take it you got home ok? Did the tires stay put on the trailer?

I got home fine and the tires stayed put well. Thanks for the strap.

Mine was on the left (like Mark's) and tied into the harness right there.

I wired in the same place. The fact that I have shared lights may be my problem. I think I'm trying to use a converter when I don't even need to - I should just be able to straight-wire it. I'll try that and keep you updated.