[Herron Performan...]

I have several LCA/PHR reducer/spacers made up and ready to go.
They are made from 4140CM and fit the XM 3/4" Rod Ends that many are using when making the Aluminum LCA/PHR set ups. You can use your stock bolts with this set up.

$10 for each end, a LCA set would be 8 total pieces and would cost $40 shipped. If you do not need a full set we can work that out.

PHR would be $20 shipped.

This post has been edited by Herron Performance: Feb 6 2008, 01:51 PM

[00 Trans Ram]

That's a good deal. When I made my LCAs, the spacers were a little cheaper. However, I had to cut them and grind them to get them to fit perfectly. I would have gladly spent a few extra $ for drop-in pieces.

Question - do you offer 2 types of LCA spacers? One for centering the arm and one for offsetting it to the inside (for more tire clearance). Just curious.

[Herron Performan...]

Yeah, the first sets i made were cutting up parts like most on here did but these are the stuff now, just 2 pcs to deal with and they fit perfectly.
I currently do not have any offset bushings made but that is very simple and if there were a few people interested I could have some of them made too.

That's a good deal. When I made my LCAs, the spacers were a little cheaper. However, I had to cut them and grind them to get them to fit perfectly. I would have gladly spent a few extra $ for drop-in pieces.

Question - do you offer 2 types of LCA spacers? One for centering the arm and one for offsetting it to the inside (for more tire clearance). Just curious.