 Wire removal advice wanted. |
|
|||||||||
 May 13 2004, 01:57 AM
Post
#1
|
|
|
Advanced Member  Group: Advanced Members Posts: 297 Joined: 14-February 04 Member No.: 203  |
I've already removed the ABS brake unit and AIR pump.
Should I pull the wires from the harness? Or, just cut them off in as far as I feel cumfortable? There's, I'm guessing, about 15-20 lineal feet, I think. Thanks Steve |
 |
 
|
 |
Replies
|
May 13 2004, 09:23 PM
Post
#2
|
|
|
FRRAX Owner/Admin Group: Admin Posts: 15,432 Joined: 13-February 04 From: Ohio Member No.: 196 |
My preferred method (I was an avionics technician) is to clip the wire, bend a 180 degree bend in it. Slip heat shrink over that and shrink it. Then, get the large heat shrink with the "glue" (industrial?) inside and shrink that over all the wires that you just cut and wrapped individually. The glue will run out the top, just trim it off and tie it out of the way.
|
|
|
|
Posts in this topic
redbird1 Wire removal advice wanted. May 13 2004, 01:57 AM
CMC#5 If you cut wires, make sure you insulate the ends ... May 13 2004, 03:23 AM rmackintosh To remove from the harness would be better, but wh... May 13 2004, 05:38 AM Zimm I did the same. Cut them back as far as I could, ... May 13 2004, 09:02 PM CMC#5 The heat shrink with the glue is the only way to g... May 14 2004, 12:21 AM
trackbird QUOTE (CMC#5 @ May 13 2004, 07:21 PM)The heat... May 14 2004, 12:33 AM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 20th June 2025 - 09:00 PM |