[trackbird]

One of the members here asked me about the 25mm adjustable rear sway bar kits to go with his new watts link (where he's going to lower the roll center). I spoke to David at Hellwig at one point and he advised me that if we had enough orders, they could do a run of them. At the time, I think we were talking about doing 10 bars. However, we may be able to get it done with a few less (I never got a hard number). The point of all this is, if we can get enough interest, I'll gladly put an order together for a group buy for the 25mm bars.

So, how many people would be interested in the 25mm adjustable rear sway bar kit from Hellwig?

Let me know and I'll see what I can do.

[trackbird]

It uses a high durometer poly end link (looks like a tie rod, but with a poly bushing instead of a ball/pivot). You could build a heim joint setup for it if you actually think you need it. I'm still running the poly and the bar works great for me, your results may vary.

I'd probably do the corner weighting. As long as you don't preload the bar, it shouldn't change much, and these may be a while (we still need at least one more buyer).

Attached File(s)

 1995_Firebird_Adj_RSB_002.jpg ( 39.96K ) Number of downloads: 29
 1995_Firebird_Adj_RSB_006.jpg ( 68.66K ) Number of downloads: 29