![]() |
|
![]() |
![]()
Post
#1
|
|
Seeking round tuits ![]() ![]() ![]() ![]() ![]() ![]() Group: Advanced Members Posts: 5,522 Joined: 24-December 03 From: Kentucky Member No.: 33 ![]() |
The Hellwig bar does not fit with the Strano/Fay Watts link. It has plenty of diff housing clearance, but it hits the center bellcrank (aka "propellor", but not by me).
It fits fine on the stock bar mounts, and that's how I installed it. However, I'm now using the Hellwig bar mounts for my Hotchkiss bar because they provide a little more clearance for the Watts axle clamps. I put a small nick in the bar's finish with a floor jack (near the center, toward the front of the car). Since it's hammertone, I rubbed in some POR-15 (very durable urethane) to prevent rust and blend in the repair. It's not invisible, but I doubt if I can get it to show up in a photo. I don't think anyone would notice even with a car-show mirror under the tail (as if ...). $125 + shipping This post has been edited by sgarnett: Oct 25 2008, 03:09 PM |
|
|
![]() |
![]()
Post
#2
|
|
Advanced Member ![]() ![]() Group: Advanced Members Posts: 715 Joined: 29-May 04 From: Cincinnati, Ohio Member No.: 352 ![]() |
|
|
|
![]()
Post
#3
|
|
North of the border ![]() ![]() ![]() Group: Admin Posts: 2,307 Joined: 4-February 04 From: Montreal, CANADA Member No.: 177 ![]() |
does that mean you are looking for one and are interested ? |
|
|
![]() ![]() |
Lo-Fi Version | Time is now: 9th May 2025 - 05:25 PM |