[ReEntryRacer]

I'm turning my accessories too fast. Can I get a BBK/ASP/March P/N that works on a ZZ4 SBC (96, 1 pc RMS, long water pump). I've searched all of these brands and I can't be sure what will work correctly. A 25% smaller dia. than stock will work, but I can't determine which one has the correct number of grooves and spacing. It would help if they published those kind of specs! I can't tell if the LT1 will work, or the 88-92 F-body, or why they're different. (IMG:http://www.frrax.com/rrforum/style_emoticons/default/huh.gif)

[trackbird]

http://www.jegs.com/i/BBK/129/1620/10002/-1

Or any of the other similar ones. I think I'm running a set from either Mr. Gasket or March. I forget, but they all work about the same. Or, call ASP and they will build you about anything you need.

[ReEntryRacer]

http://www.jegs.com/i/BBK/129/1620/10002/-1

Or any of the other similar ones. I think I'm running a set from either Mr. Gasket or March. I forget, but they all work about the same. Or, call ASP and they will build you about anything you need.

Thanks Kevin, I did see that BBK sells sets, but I don't think I can get a bigger pulley on my PS pump, so I'm not inclined to buy the whole set since I can't use that pulley anyway.
PS I'm finally putting some money into an envelope for you as I type this!

[trackbird]

http://www.jegs.com/i/BBK/129/1620/10002/-1

Or any of the other similar ones. I think I'm running a set from either Mr. Gasket or March. I forget, but they all work about the same. Or, call ASP and they will build you about anything you need.

Thanks Kevin, I did see that BBK sells sets, but I don't think I can get a bigger pulley on my PS pump, so I'm not inclined to buy the whole set since I can't use that pulley anyway.
PS I'm finally putting some money into an envelope for you as I type this!

I have a two piece set. They are doing 3 because they are shiny aluminum (pretty) and match. You don't need that set, or to change the PS pulley.

Try this:

http://www.aspracing.com/gm.htm#camaro


Mr Gaskets site is down (well, you can't seem to go anywhere right now), but I think mine came from them. It was a two piece kit in a box, but it's been a long time since they were purchased.

Edit:

March 655-4000 (jegs number, march number is just 4000)

http://www.jegs.com/p/March+Performance/748685/10002/-1

These are all for the factory serpentine setup. (which I just realized you probably don't have).

March does one for an early 3rd gen too (655-4020).

Sorry, I caught 88-92 in your post and thought you had the later serpentine setup. You'll need that 655-4020 for an earlier setup. It's on the same page as the link I just posted.