|
||||
May 31 2004, 06:32 AM
Post
#1
|
|
|
Insert catch phrase here ![]() ![]() ![]() Group: Advanced Members Posts: 2,098 Joined: 23-December 03 From: Michigan Member No.: 20 |
Are the fans in series in our LT1 engines? Can I remove one of them and still have one working fan? I'm in the middle of doing a few things on the car and the engine isn't running so I'm hoping someone knows before I reinstall everything.
|
|
|
|
![]() |
Jun 2 2004, 12:33 AM
Post
#2
|
|
|
Insert catch phrase here ![]() ![]() ![]() Group: Advanced Members Posts: 2,098 Joined: 23-December 03 From: Michigan Member No.: 20 |
From Shoebox's site:
There are two versions of the dual fan configuration: 1993-1994 - Primary and Secondary fans that operate at only one speed. When initially commanded on, only the primary fan (driver side) comes on. It operates alone at full speed. If the temp threshold is met for addtional cooling, the secondary fan (passenger side) also is commanded on. At this point, both fans are running at full speed. These fans use a two relay architecture that can be seen in the fuse/relay panel that is under the hood. In late 1994 and into 1995, there was a change to low and high speed fans. When initially commanded on, both fans will come on at a low speed. When the high speed temp threshold is met, they both bump up to high speed. A three relay architecture is used for this fan version (seen in the fuse/relay panel). By adding a third relay, low speed can be achieved by running the power to the fans in series. This way, each fan does not get full voltage and runs at a slower speed. High speed happens when the relays switch to provide full voltage to both fans. Low speed is less noisy and should result in greater fan longevity. High speed is not always needed. ================== Note the comment about 2 vs. 3 relays. Just checked mine and I have 3 relays, so I guess I have the newer setup. I knew I hadn't seen my fans come on individually before. |
|
|
|
94bird Cooling fan operation May 31 2004, 06:32 AM
Jon A On your '94 you have one fan that kicks on fir... May 31 2004, 06:56 AM
94bird I've decided to modify my testing at the track... May 31 2004, 01:48 PM
rmackintosh Mike, I tried removing one fan and both when my ca... May 31 2004, 06:22 PM
94bird I'm quite surprised that with the BeCool radia... May 31 2004, 10:15 PM
Jon A I wonder if there isn't something else going o... Jun 1 2004, 01:15 AM
94bird I started looking at my shrouds more over the past... Jun 1 2004, 03:03 AM
#07 QUOTE (Jon A @ May 31 2004, 07:15 PM)Have you... Jun 1 2004, 03:09 AM
94bird Tony, some foam works great to seal up the gap and... Jun 1 2004, 03:25 AM
rmackintosh QUOTE Have you guys who have taken it out really s... Jun 1 2004, 04:12 AM
Jon A Keep in the weather in mind. I did see a bit over... Jun 1 2004, 04:56 AM
#07 QUOTE (#07 @ May 31 2004, 09:09 PM)I was amaz... Jun 1 2004, 05:23 AM
rmackintosh QUOTE I wonder if on the stock 94 fan set-up if yo... Jun 1 2004, 06:03 AM
Jon A It's a wiring issue. The 96-up cars are wired... Jun 1 2004, 08:01 AM
94bird I found a Hayden slimline fan 16" in diameter... Jun 1 2004, 05:55 PM
94bird QUOTE (rmackintosh @ Jun 1 2004, 12:12 AM)QUO... Jun 1 2004, 05:57 PM
94bird I measured the size of my plastic deflector that d... Jun 1 2004, 11:24 PM
robz71lm7 QUOTE (Jon A @ May 31 2004, 02:56 AM)On your ... Jun 1 2004, 11:58 PM
ESPCamaro What setup did the 93 cars have. I thought that th... Jun 2 2004, 02:07 AM
94bird Each fan weighs 5.5 lbs., with the total assy of 2... Jun 2 2004, 02:16 AM
ESPCamaro Really?!!
They feel much heavier. Or did ... Jun 2 2004, 02:22 AM
Soma07 I believe the V6 cars had a single fan but the sam... Jun 2 2004, 02:53 AM
#07 QUOTE (94bird @ Jun 1 2004, 06:33 PM)By addin... Jun 2 2004, 02:55 AM
94bird I believe the wiring would also have to be updated... Jun 2 2004, 02:58 AM
#07 QUOTE (Soma07 @ Jun 1 2004, 08:53 PM)I believ... Jun 2 2004, 03:05 AM
#07 QUOTE (94bird @ Jun 1 2004, 08:58 PM)I believ... Jun 2 2004, 03:08 AM
rmackintosh Mike...
My front breather opening is 3 1/2 tall b... Jun 2 2004, 03:23 AM
CMC#5 See, that was my impression also, that fans don... Jun 2 2004, 03:59 AM
Jon A Interesting, guys. I didn't know they made th... Jun 2 2004, 07:31 PM
Sam Strano QUOTE (rmackintosh @ May 31 2004, 10:12 PM)I ... Jun 2 2004, 08:37 PM
rmackintosh QUOTE (sam@stranoparts.com @ Jun 2 2004, 02:3... Jun 2 2004, 10:10 PM
94bird Jon, your last post is right along the lines of wh... Jun 3 2004, 01:18 AM
94bird Well, I got myself motivated and am making my car ... Jun 5 2004, 04:48 AM
#07 Sounds really cool,Makes me want to do this too. L... Jun 6 2004, 06:53 PM
94bird I've blocked off the air flow from the black p... Jun 6 2004, 08:00 PM![]() ![]() |
| Lo-Fi Version | Time is now: 9th November 2025 - 10:15 PM |