[JimMueller]

I took my daily driver to a little road race practice course today. Each lap was only a minute and I'd stay out there for only 5-10 minutes. The first session I just wanted to work on tire temps, then I let it cool down. I actually logged the second session and have some questions.

Water temp: I live in Florida, so I run 100% distilled water with maybe 1-2 bottles of water wetter. After 7 laps, I noticed the coolant temp was at the 3/4 mark so I brought the car in. The scan tool later revealed the temp had peaked at 244*. Isn't that a bit warm? Solutions?

Brakes: In the front I have standard C6 calipers, Trackbrackets, DTC-30 pads, new standard C6 rotors. In the rear I have Powerslot rotors and HPS pads. All stainless lines and using SRF fluid. While it didn't have a problem stopping, the pedal became easier to depress and started grabbing hard closer to the floor. I didn't like the feel of this, how do I remedy it?

The log also shows it was pulling 4* of timing on all WOT sections. I bet I have a knock sensor code (IMG:http://www.frrax.com/rrforum/style_emoticons/default/mad.gif)

[JimMueller]

Almost overheated yesterday. Added water and it seemed to be dripping from the driver side of the radiator. Dealer confirmed with a pressure test that the radiator is leaking. Right now I'm using distilled water & water wetter (although it's seriously diluted at this point). Should I use some radiator stop leak and then start shopping around for a LT1 radiator (that's better than the LS1, right?) Else it gets expensive for the aftermarket radiators... Ron Davis seems like >$800, LGM was over $1000, etc.