 1LE hubs |
|
|||||||||
 Apr 16 2012, 08:58 PM
Post
#1
|
|
|
Veteran Member  Group: Advanced Members Posts: 2,511 Joined: 14-November 04 From: Homer Glen, IL Member No.: 540  |
I have two pairs of 1LE rotors that have been cut down into hubs and already have ARP studs pressed in them (before machining). IIRC, they are the 7708 studs (normal extended length, not the super long ones).
They were made from NOS 1LE rotors and have never been run. Both sets have light surface rust from sitting in a box for years, but nothing that will effect their use. $175 shipped for each pair. |
 |
 
|
 |
Replies
|
Apr 16 2012, 10:05 PM
Post
#2
|
|
|
Experienced Member Group: Advanced Members Posts: 2,290 Joined: 4-May 04 From: Kenvil, NJ Member No.: 331 |
Do you know what you cut the outside diameter to? Are they straight cut or flared out towards the head of the wheel studs? No rust on the bearing races, right?
This post has been edited by slowTA: Apr 16 2012, 10:05 PM |
|
|
|
Posts in this topic
nape 1LE hubs Apr 16 2012, 08:58 PM
nape I believe the OD is 5.900" if I remember righ... Apr 18 2012, 02:26 AM
slowTA If the races were covered in grease then they... Apr 19 2012, 04:51 PM |
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 4th November 2025 - 11:12 AM |