[robz71lm7]

Since this has no useful tech and has been covered previously I thought I'd post my rant in here.

This applies to the '93+ F-body.

I just took the front lca's off my car. I replaced the bushings in them with Energy Suspension bushings in the summer. Well after just a few autocross events the caster bushings on BOTH sides are ripped in half and one side had almost spit the bushing completely out. (The caster bushing are the rear bushing on the front LCA's).

I was mainly doing this to replace them as preventive maintenance. I had read where others had experienced a caster bushing failure and didn't want to take a risk of it happening mid summer.

I have a set of prothane poly bushings here. The caster bushing on these is completely different and looks much stouter-however I don't know what it will do.

Others have used the Moog replacement caster bushing sucessfully-use that if you're looking for a replacement.

Also from what I can tell the bushings have been shot for a while which might explain some ( not all) of my car's nasty behavior over bumps and dead feeling in slaloms. (IMG:http://www.frrax.com/rrforum/style_emoticons/default/rant2.gif) GRRRR.

[Formula WS6]

man im glad i read this. i figured since id need to remove my lower arm for the ball joint that id go ahead and do the bushings. guess ill get the Moogs now in stead of the energy suspension ones.

on that note. i havent even looked into it in the book, but how hard is it to get the lower arms off? ill only have the car on jack stands. do i need to get it really high off the ground? man no longer having a lift sucks