How to turn airbag light off? - F-Body Road Racing and Autocross Forums

Replies

Teutonic Speedra... Teutonic Speedracer View Member Profile	Feb 5 2005, 11:14 PM Post #2
LS1 Inside! / Toolbox / Mechanical Engineer Group: Advanced Members Posts: 2,215 Joined: 5-February 04 From: NJ Member No.: 179	QUOTE (John_D. @ Feb 5 2005, 04:36 PM) If you remove the airbag controller in the console, does the light go out then? No, that's been out for a long time! I tried 2.2 kohm resistors in both driver and passenger airbag connectors earlier today, and the light still comes on.

Posts in this topic

Teutonic Speedracer How to turn airbag light off? Aug 20 2004, 01:00 AM

Cal No, it goes through it's own dedicated control... Aug 20 2004, 03:51 AM

LT4Firehawk The other way to do it is to dremel through the co... Aug 20 2004, 01:47 PM

felton316 It should be a 2 ohm resistor per bag. Steering w... Aug 21 2004, 12:19 AM

Teutonic Speedracer OK, I'm finally getting back to this. These r... Feb 5 2005, 03:09 PM

John_D. If you remove the airbag controller in the console... Feb 5 2005, 09:36 PM

Teutonic Speedracer QUOTE (John_D. @ Feb 5 2005, 04:36 PM)If you ... Feb 5 2005, 11:14 PM

LT4Firehawk Dremel it. It's a rather permanent solutio... Feb 5 2005, 11:16 PM

Teutonic Speedracer QUOTE (LT4Firehawk @ Feb 5 2005, 06:16 PM)Dre... Feb 5 2005, 11:32 PM

felton316 QUOTE (Teutonic Speedracer @ Feb 5 2005, 09:0... Feb 6 2005, 02:04 AM

Teutonic Speedracer QUOTE (felton316 @ Feb 5 2005, 09:04 PM)It sh... Feb 6 2005, 09:42 PM

felton316 Do you still have the control module in the center... Feb 7 2005, 03:46 AM

John_D. QUOTE (Teutonic Speedracer @ Feb 5 2005, 05:1... Feb 7 2005, 03:58 AM

Teutonic Speedracer QUOTE (felton316 @ Feb 6 2005, 10:46 PM)Do yo... Feb 7 2005, 04:23 AM

felton316 I beleive the resistor trick only works if the con... Feb 8 2005, 01:41 AM

Teutonic Speedracer I'd like to pull the bulb or cut the wire, but... Feb 8 2005, 02:26 AM

marka Howdy, Back to life... I have this exact problem... Jun 18 2007, 04:15 PM

John_D. The only other thing I can think of that could tri... Jun 20 2007, 04:20 PM

1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)

0 Members:

Teutonic Speedra... Teutonic Speedracer View Member Profile	Aug 20 2004, 01:00 AM Post #1
LS1 Inside! / Toolbox / Mechanical Engineer Group: Advanced Members Posts: 2,215 Joined: 5-February 04 From: NJ Member No.: 179	Is there a way to turn the airbag light off using LS1Edit? Since I disconnected the airbags, the light flashes, attempts to pump, then the airbag light and service engine light comes on all the time.