How to turn airbag light off? - F-Body Road Racing and Autocross Forums

Replies

John_D. View Member Profile	Feb 7 2005, 03:58 AM Post #2
Engine and Tools Moderator Group: Advanced Members Posts: 1,859 Joined: 23-December 03 From: Lebanon TN Member No.: 6	QUOTE (Teutonic Speedracer @ Feb 5 2005, 05:14 PM) QUOTE (John_D. @ Feb 5 2005, 04:36 PM) If you remove the airbag controller in the console, does the light go out then? No, that's been out for a long time! Sounds like this must be it. Guess I need to put my module back in too...

Posts in this topic

Teutonic Speedracer How to turn airbag light off? Aug 20 2004, 01:00 AM

Cal No, it goes through it's own dedicated control... Aug 20 2004, 03:51 AM

LT4Firehawk The other way to do it is to dremel through the co... Aug 20 2004, 01:47 PM

felton316 It should be a 2 ohm resistor per bag. Steering w... Aug 21 2004, 12:19 AM

Teutonic Speedracer OK, I'm finally getting back to this. These r... Feb 5 2005, 03:09 PM

John_D. If you remove the airbag controller in the console... Feb 5 2005, 09:36 PM

Teutonic Speedracer QUOTE (John_D. @ Feb 5 2005, 04:36 PM)If you ... Feb 5 2005, 11:14 PM

LT4Firehawk Dremel it. It's a rather permanent solutio... Feb 5 2005, 11:16 PM

Teutonic Speedracer QUOTE (LT4Firehawk @ Feb 5 2005, 06:16 PM)Dre... Feb 5 2005, 11:32 PM

felton316 QUOTE (Teutonic Speedracer @ Feb 5 2005, 09:0... Feb 6 2005, 02:04 AM

Teutonic Speedracer QUOTE (felton316 @ Feb 5 2005, 09:04 PM)It sh... Feb 6 2005, 09:42 PM

felton316 Do you still have the control module in the center... Feb 7 2005, 03:46 AM

John_D. QUOTE (Teutonic Speedracer @ Feb 5 2005, 05:1... Feb 7 2005, 03:58 AM

Teutonic Speedracer QUOTE (felton316 @ Feb 6 2005, 10:46 PM)Do yo... Feb 7 2005, 04:23 AM

felton316 I beleive the resistor trick only works if the con... Feb 8 2005, 01:41 AM

Teutonic Speedracer I'd like to pull the bulb or cut the wire, but... Feb 8 2005, 02:26 AM

marka Howdy, Back to life... I have this exact problem... Jun 18 2007, 04:15 PM

John_D. The only other thing I can think of that could tri... Jun 20 2007, 04:20 PM

1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)

0 Members:

Teutonic Speedra... Teutonic Speedracer View Member Profile	Aug 20 2004, 01:00 AM Post #1
LS1 Inside! / Toolbox / Mechanical Engineer Group: Advanced Members Posts: 2,215 Joined: 5-February 04 From: NJ Member No.: 179	Is there a way to turn the airbag light off using LS1Edit? Since I disconnected the airbags, the light flashes, attempts to pump, then the airbag light and service engine light comes on all the time.