IPB

Welcome Guest ( Log In | Register )

Solo PerformanceUnbalanced EngineeringBlaine Fabrication.comUMI PerformanceHotpart.com
> Beaver Run, Anybody with experiance @ this Track??
GM01SS
post Jun 22 2005, 01:02 AM
Post #1


Nitto Destroyer!
*

Group: Advanced Members
Posts: 248
Joined: 24-December 03
From: Rochester NY
Member No.: 29



Greetings! Like the title says, I am going to Beaverun for the first time with the local BMW group. Looking for any info as to track layout out ,quirks etc.

Thanks in advance

Gary
Go to the top of the page
 
+Quote Post
 
Start new topic
Replies
Ojustracing
post Jun 23 2005, 02:47 AM
Post #2


Advanced Member
**

Group: Advanced Members
Posts: 919
Joined: 30-December 03
From: Northern NY
Member No.: 66



QUOTE (KeithO @ Jun 22 2005, 06:16)
.

Turn 7 is a blind, off camber, downhill, right-hander. After a couple of laps, you will end up picking a tree out on the horizon to use for your turn-in point since you can't see the apex. Cars with good grip and medium to low power can take this flatfooted. My car MIGHT be able to take this turn flat-footed, but I haven't gained the courage to do this yet. I plan to do some testing later this year and try.

Turn 9 is really a kink on the backstraight. Like turn 7, many cars can take this flat-out. I tap the brakes in a straight line there (I'm in 5th gear) then floor it using all of the track and start braking for 10 as soon as the car is heading straight. DO NOT LIFT GOING INTO THE KINK. I have seen literally scores of cars destroyed at this turn. The driver first chooses to take it flat-footed then changes his mind after initial turn-in. The lift rotates the car and you will end up hitting the Armco with the passenger side. Creep up on speed through this turn slowly.

Turn 10 is a sharp, uphill right-hander. I have tried many lines through here and for my current configuration (low power), I found that taking the turn in the middle and tracking out to the outer curbing helps me carry more speed up the hill and onto the front-straight. A higher hp car might benefit from a tighter (and thus shorter) line but it's down to the car.


Beaver Run is extremely hard on brakes. In fact, I have driven about 10 tracks and this is by far the hardest on the brakes. Make sure that your pads have lots of life left and make sure that your brake fluid is fresh.

When are you going?

I Have to agree with Keith here too. All of his points are valid and true. Turn 7 flat footed! Damm I Know where Im loosing all my time!! That whole back session.

I also hear it was hard on brakes too. I never had any issues with brakes there, but I was running race pads, new fluid, and Brake ducts. Brakes were junk after the weekend though. I've been to a couple different tracks that were worse, but having 2 130mph+- braking zones within 12 sec or so of each other will do that. Enjoy that track it was my first road Course track and has been one of the funest tracks Ive been too. John
Go to the top of the page
 
+Quote Post

Posts in this topic
GM01SS   Beaver Run   Jun 22 2005, 01:02 AM
KeithO   You can get a track map at: http://www.beaverun.c...   Jun 22 2005, 12:16 PM
Ojustracing   QUOTE (KeithO @ Jun 22 2005, 06:16). Turn 7 ...   Jun 23 2005, 02:47 AM
GM01SS   Thanks to all that have replied! Will be ther...   Jun 23 2005, 12:41 PM

« Next Oldest · Events · Next Newest »
 

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: 19th June 2025 - 09:28 PM