![]() |
|
![]() |
![]()
Post
#1
|
|
No El-Use-O. ![]() ![]() ![]() Group: Advanced Members Posts: 2,368 Joined: 27-December 03 From: SW Michigan Member No.: 52 ![]() |
These do need a rebuild. I bought them for a lowered PHR setup and planned to send them out for a rebuild/revalve....
I paid $50. Would like to get the same as I paid out of them. PLUS shipping..... Also FS one Blue Simpson 5 point. It dirty and no idea what the date it, but it does function, and no worn areas....$35 PLUS shipping. Perfect for an autox car. Also will have a set of perfectly good Bilstein 4th gen rear shocks...I won't sell these until I get replacements (new Koni SA's) but will sell them once I round up the cash...Sell cheap too. Say $45 PLUS shipping. Also could have a set of crossdrilled LT1 rotors. Make an offer. Not sure of the miles but don't look worn. A little rusty But I'll sandblast them to look good as new. Also have a brand new set of ProThane rear control arm poly bushings.....Make offer... Also a set of Koni reds for a 2nd gen f-body. Sold as NOS on e-bay. They were just a little rusty on the outside, but I could tell they had never been used. The hardware was new etc.... CHEAP $30 shipped.....This is for the rear only. |
|
|
![]() |
![]()
Post
#2
|
|
Member ![]() Group: Advanced Members Posts: 207 Joined: 26-September 04 From: SoCal Baby! Member No.: 472 ![]() |
Thanks man. I was just really hoping to get them by today. I was going to go on the Rim of The World cruise out here in cali, but the motor isnt in yet, so even if I get it finished tonight, I wont have any time to do the exhaust and alignment before the start of the cruise tomorrow!
Oh well... If you could check it out though, that would be epic! Thanks again! |
|
|
![]() ![]() |
Lo-Fi Version | Time is now: 18th May 2025 - 10:55 AM |