New SLP bolt-in SFCs for 4th gen - F-Body Road Racing and Autocross Forums

The short version is that it would have been much easier to install these BEFORE I installed the Unbalanced Engineering Decoupled Torque Arm. They can coexist, but it's difficult to retrofit the SFCs later. Racing season arrived, and I had to cut my losses and move on.

These are the standard 4th gen fbody 3-point bolt-ons, powdercoated black. They will not fit a convertible. They have only been loosely test-fitted. Other than one rear LCA bolt that was snugged, they have never been tightened down or "formed" to my car, and of course they have never been driven.

There are a few minor scrapes in the powdercoat from shipping and test fitting.

I also drilled one extra mounting hole in the center of the tunnel brace mounting tab on one side. It will be covered up by the tunnel brace and won't show.

I painted the bare steel threaded nut-plates with "cold galvanizing" zinc primer and a quick top coat of black just for corrosion protection (they are hidden when installed) and substituted new grade 8 bolts (included) for the grade 5 that SLP supplied.

$225 plus shipping sold

This post has been edited by sgarnett: Aug 13 2006, 07:50 PM

sgarnett View Member Profile	Mar 5 2006, 01:17 AM Post #1
Seeking round tuits Group: Advanced Members Posts: 5,522 Joined: 24-December 03 From: Kentucky Member No.: 33	The short version is that it would have been much easier to install these BEFORE I installed the Unbalanced Engineering Decoupled Torque Arm. They can coexist, but it's difficult to retrofit the SFCs later. Racing season arrived, and I had to cut my losses and move on. These are the standard 4th gen fbody 3-point bolt-ons, powdercoated black. They will not fit a convertible. They have only been loosely test-fitted. Other than one rear LCA bolt that was snugged, they have never been tightened down or "formed" to my car, and of course they have never been driven. There are a few minor scrapes in the powdercoat from shipping and test fitting. I also drilled one extra mounting hole in the center of the tunnel brace mounting tab on one side. It will be covered up by the tunnel brace and won't show. I painted the bare steel threaded nut-plates with "cold galvanizing" zinc primer and a quick top coat of black just for corrosion protection (they are hidden when installed) and substituted new grade 8 bolts (included) for the grade 5 that SLP supplied. $225 plus shipping sold This post has been edited by sgarnett: Aug 13 2006, 07:50 PM

sgarnett View Member Profile	Aug 10 2006, 01:31 PM Post #2
Seeking round tuits Group: Advanced Members Posts: 5,522 Joined: 24-December 03 From: Kentucky Member No.: 33	price reduced