![]() |
|
![]() |
![]()
Post
#1
|
|
Engine and Tools Moderator ![]() ![]() ![]() Group: Advanced Members Posts: 1,859 Joined: 23-December 03 From: Lebanon TN Member No.: 6 ![]() |
I cut a hole big enough to slide the pcm connectors through.
But there is no grommet big enough (that I can find) to seal it up. Did you make some kind of 2-piece cover plate to go over the hole? Fill it with putty? Some other solution? (it took a pretty good size hole to get a pcm connector (and the wire bundle on top of the connector) to go through) Maybe everybody else just pushed all the small stuff through from the inside of the car, instead of pushing the big stuff through from the engine bay side...? |
|
|
![]() |
![]()
Post
#2
|
|
Advanced Member ![]() ![]() Group: Advanced Members Posts: 813 Joined: 21-January 04 From: Santa Barbara, CA Member No.: 141 ![]() |
Our pcm is still in the engine compartment, but for other holes in the firewall (heater core, some hole on the driver's side) we've covered them with aluminum sheets and either used sheet metal screws or pop rivets to keep it in place.
Jason |
|
|
![]() ![]() |
Lo-Fi Version | Time is now: 10th July 2025 - 10:17 PM |