ls1 radiator/steam vents - F-Body Road Racing and Autocross Forums

A few months back, I asked about radiators for my LS1 firebird. Trying to keep cost down, I was looking at a universal radiator. A member suggested AFCO. And others ask for me to get back with what I found. So here goes, I looked at their site and I am thinking of going with their 27.5 X 19 X 3 double pass radiator. The price was right 224.00. Being it is real close, other that thickness, to the stock dimenions, should be a real easy fab to install.
My only question, LS1 motors have steam vent lines coming off the cylinder heads. These lines go directly back to the radiator just below the radiator cap bottom seal area. Just above it is the overflow outlet that sits between the top of the cap and the bottom seal area of the cap. This AFCO radiator only provides for the overflow line. It has no provesion for the vent lines. Will I need to drill and weld in a vent line outlet into the side housing? And does the height of where the vent line goes on the radiator critical. I now higher is better.
Any thoughts on the steam vent issue would be apprecated.
Ed
Something else came to mine, do I need the temp switch outlet to run anything in the computer other than fans? I will be switching to a small manual one for cool down laps.

This post has been edited by fasteddiewick: Feb 14 2008, 08:51 PM

fasteddiewick View Member Profile	Feb 14 2008, 07:48 PM Post #1
Member Group: Advanced Members Posts: 37 Joined: 21-July 06 Member No.: 1,290	A few months back, I asked about radiators for my LS1 firebird. Trying to keep cost down, I was looking at a universal radiator. A member suggested AFCO. And others ask for me to get back with what I found. So here goes, I looked at their site and I am thinking of going with their 27.5 X 19 X 3 double pass radiator. The price was right 224.00. Being it is real close, other that thickness, to the stock dimenions, should be a real easy fab to install. My only question, LS1 motors have steam vent lines coming off the cylinder heads. These lines go directly back to the radiator just below the radiator cap bottom seal area. Just above it is the overflow outlet that sits between the top of the cap and the bottom seal area of the cap. This AFCO radiator only provides for the overflow line. It has no provesion for the vent lines. Will I need to drill and weld in a vent line outlet into the side housing? And does the height of where the vent line goes on the radiator critical. I now higher is better. Any thoughts on the steam vent issue would be apprecated. Ed Something else came to mine, do I need the temp switch outlet to run anything in the computer other than fans? I will be switching to a small manual one for cool down laps. This post has been edited by fasteddiewick: Feb 14 2008, 08:51 PM