 LT1 heads for sale |
|
|||||||||
  |
 Dec 10 2007, 03:14 PM
Post
#1
|
|
|
Nothing says 'I love you.' like a box of Hydroshoks  Group: Moderators Posts: 5,284 Joined: 23-December 03 From: Granbury, TX Member No.: 4  |
From a 96 LT1.
The heads have been freshly built by Wayne Calvert in Denton. They are complete with fresh seats and valves, angle cut valve job, new LT4 springs and locks. Unfortunately, I can't use them. They had been cut previously and he cut another .015 off to get them flat. That would put the compression ratio to 11.2 to 1 which is over the limit of the rule set I run under. The combustion chambers are measured at 52cc. These will bolt right on and you get a nice bump in compression. Looking for $450 plus a set of good cores. Heads are located in Ft. Worth, Tx. |
 |
 
|
|
Dec 16 2007, 03:50 PM
Post
#2
|
|
|
Nothing says 'I love you.' like a box of Hydroshoks Group: Moderators Posts: 5,284 Joined: 23-December 03 From: Granbury, TX Member No.: 4 |
Bump
|
|
|
|
|
Dec 22 2007, 02:46 PM
Post
#3
|
|
|
newbie Group: Advanced Members Posts: 20 Joined: 4-June 07 From: Clearwater, FL Member No.: 1,814 |
QUOTE (mitchntx @ Dec 16 2007, 10:50 AM)  Bump Are they ported at all? |
|
|
|
|
Dec 23 2007, 05:53 AM
Post
#4
|
|
|
Nothing says 'I love you.' like a box of Hydroshoks Group: Moderators Posts: 5,284 Joined: 23-December 03 From: Granbury, TX Member No.: 4 |
No ... unported.
|
|
|
|
|
Dec 23 2007, 02:27 PM
Post
#5
|
|
|
Veteran Member Group: Advanced Members Posts: 2,511 Joined: 14-November 04 From: Homer Glen, IL Member No.: 540 |
Mitch, can't you run a thicker head gasket to get around the .015" he cut?
|
|
|
|
|
Dec 23 2007, 03:01 PM
Post
#6
|
|
|
Nothing says 'I love you.' like a box of Hydroshoks Group: Moderators Posts: 5,284 Joined: 23-December 03 From: Granbury, TX Member No.: 4 |
QUOTE (nape @ Dec 23 2007, 08:27 AM) Mitch, can't you run a thicker head gasket to get around the .015" he cut? If the heads had only been cut once, yes. I would keep them. But they had already been cut once before. |
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 10th May 2025 - 11:26 AM |