 LT1 heads for sale |
|
|||||||||
 Dec 10 2007, 03:14 PM
Post
#1
|
|
|
Nothing says 'I love you.' like a box of Hydroshoks  Group: Moderators Posts: 5,284 Joined: 23-December 03 From: Granbury, TX Member No.: 4  |
From a 96 LT1.
The heads have been freshly built by Wayne Calvert in Denton. They are complete with fresh seats and valves, angle cut valve job, new LT4 springs and locks. Unfortunately, I can't use them. They had been cut previously and he cut another .015 off to get them flat. That would put the compression ratio to 11.2 to 1 which is over the limit of the rule set I run under. The combustion chambers are measured at 52cc. These will bolt right on and you get a nice bump in compression. Looking for $450 plus a set of good cores. Heads are located in Ft. Worth, Tx. |
 |
 
|
Posts in this topic
mitchntx LT1 heads for sale Dec 10 2007, 03:14 PM
mitchntx Bump Dec 16 2007, 03:50 PM
SS1156 QUOTE (mitchntx @ Dec 16 2007, 10:50 AM) ... Dec 22 2007, 02:46 PM mitchntx No ... unported. Dec 23 2007, 05:53 AM nape Mitch, can't you run a thicker head gasket to ... Dec 23 2007, 02:27 PM mitchntx QUOTE (nape @ Dec 23 2007, 08:27 AM) Mitc... Dec 23 2007, 03:01 PM  |
3 User(s) are reading this topic (3 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 10th May 2025 - 05:46 AM |