1991 Corvette parts for sale (short block, wheels, etc) Options

[trackbird]

Copied from my Craigslist posting:

I've been working on a 1991 Corvette project and I've gathered up a lot of extra parts. It's time to clean out the garage.

I've been working on a 1991 Corvette project and I've gathered up a lot of extra parts. It's time to clean out the garage.

1991 factory Corvette 5.7 liter (350) V8 "shortblock" (pistons, rods, cam, lifters, pushrods, timing chain, timing cover, crank, harmonic balancer). 117k miles on it, ran great and didn't smoke or use oil.

$250 local pickup only


Corvette "J55" heavy duty brake caliper brackets (just add the correct calipers and rotors to upgrade to the 13" factory heavy duty brake kit).

$90


Accell 36 lb/hr injectors. Used, decent condition.

$85


Factory Dana 44 limited slip rebuild kit (Posi rebuild clutches and steels). New in the box.

$65


4 Heavy duty universal joints for the rear half shafts. New in the box.

$70


Spare aluminum rear half shafts (from a roughly '93 Corvette).

$65


Set of 4 17x9.5" machined finish "Sawblades" wheels with center caps.

$175 Local pickup only


Set of 4 17x9.5" painted finish "Sawblades" wheels (no center caps). I bought these from someone who had them refinished and they were never used.

$325 Local pickup only


MSD Shift light (LED version that uses MSD rpm modules) and a set of RPM modules (6,100-6,900 rpm). Used, in very good condition (the mounting bracket was bent slightly to mount it on a roll cage tube, otherwise it's nearly new and only has about an hour of run time on it).

$75


Corvette "letters" for the molded in "CORVETTE" on the back of the 1991to 1996 Corvettes. Black letters with adhesive backing made out of a black finish material (I'm thinking it's a plastic, but they are still sealed in the package).

$25


6 speed Corvette rubber shift boot (the one that seals the shifter to the transmission tunnel, not the leather one inside the car). New in the box, aftermarket boot.

$40


Z51 factory road race/autocross springs for sale (Spring codes FHB and NYU). I have a Z51 front spring that I gathered up for my 1991 Corvette project but never installed. It is a used spring, but in very good condition. I've decided to stick to part out my project car, so I'm offering it for sale. The front spring is marked FHB. It has no wedges and the rubber bushings have been trimmed.

Pics on request.

$95 plus freight OBO

I also have a rear Z51spring (code NYU) that has stock spacers on it, used but in good condition.

$95 OBO


Pics on request.

trackbird (at) gmail dot com

[trackbird]

Prices reduced.