IPB

Welcome Guest ( Log In | Register )

 Forum Rules 
Hotpart.comUMI PerformanceSolo PerformanceBlaine Fabrication.comUnbalanced Engineering
> How to turn airbag light off?
Teutonic Speedra...
post Aug 20 2004, 01:00 AM
Post #1


LS1 Inside! / Toolbox / Mechanical Engineer
***

Group: Advanced Members
Posts: 2,215
Joined: 5-February 04
From: NJ
Member No.: 179



Is there a way to turn the airbag light off using LS1Edit? Since I disconnected the airbags, the light flashes, attempts to pump, then the airbag light and service engine light comes on all the time.
Go to the top of the page
 
+Quote Post

Posts in this topic
Teutonic Speedracer   How to turn airbag light off?   Aug 20 2004, 01:00 AM
Cal   No, it goes through it's own dedicated control...   Aug 20 2004, 03:51 AM
LT4Firehawk   The other way to do it is to dremel through the co...   Aug 20 2004, 01:47 PM
felton316   It should be a 2 ohm resistor per bag. Steering w...   Aug 21 2004, 12:19 AM
Teutonic Speedracer   OK, I'm finally getting back to this. These r...   Feb 5 2005, 03:09 PM
John_D.   If you remove the airbag controller in the console...   Feb 5 2005, 09:36 PM
Teutonic Speedracer   QUOTE (John_D. @ Feb 5 2005, 04:36 PM)If you ...   Feb 5 2005, 11:14 PM
LT4Firehawk   Dremel it. It's a rather permanent solutio...   Feb 5 2005, 11:16 PM
Teutonic Speedracer   QUOTE (LT4Firehawk @ Feb 5 2005, 06:16 PM)Dre...   Feb 5 2005, 11:32 PM
felton316   QUOTE (Teutonic Speedracer @ Feb 5 2005, 09:0...   Feb 6 2005, 02:04 AM
Teutonic Speedracer   QUOTE (felton316 @ Feb 5 2005, 09:04 PM)It sh...   Feb 6 2005, 09:42 PM
felton316   Do you still have the control module in the center...   Feb 7 2005, 03:46 AM
John_D.   QUOTE (Teutonic Speedracer @ Feb 5 2005, 05:1...   Feb 7 2005, 03:58 AM
Teutonic Speedracer   QUOTE (felton316 @ Feb 6 2005, 10:46 PM)Do yo...   Feb 7 2005, 04:23 AM
felton316   I beleive the resistor trick only works if the con...   Feb 8 2005, 01:41 AM
Teutonic Speedracer   I'd like to pull the bulb or cut the wire, but...   Feb 8 2005, 02:26 AM
marka   Howdy, Back to life... I have this exact problem...   Jun 18 2007, 04:15 PM
John_D.   The only other thing I can think of that could tri...   Jun 20 2007, 04:20 PM

« Next Oldest · General Discussion · Next Newest »
 

Reply to this topicStart new topic
4 User(s) are reading this topic (4 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: 8th May 2025 - 03:03 AM