I bought one of the billet clutch reservoirs from Hawks (see link below). I was going to install it today and the tab end is a little tight in the 4th gen bracket. I figure deburring the bracket might do the trick or a light sanding to the underside of the tab. I'd spent enough time upside down under the dash today that I decided I didn't care and I just put the OEM replacement in place. I ordered this with the new rubber insert (listed as a $10 option, $110 total).
http://www.hawksmotorsports.com/84-2002-camaro-firebird-billet-aluminum-black-clutch-reservoir-w-bracket-cap/
$80 plus freight.
Sadly, I don't suspect this is going to sell here, but I still have it.
yeah some of the Clean Engine Bay type people might like it
It looks nice, I bet it would sell on ls1tech
It's certainly not my style. I just didn't trust the quality of the replacement plastic versions and I was afraid I'd get a flimsy POS that would just crack. I bought this one in case the other one was crap. I didn't want to reuse my old one since it was full of crap and it looked a little stressed around the bottom and I figured I'd break it while getting the hose off of it.
$60 shipped.
Is this the black version (like the link indicates) ?
If so I'll take it.
~DaVe
Dang. Just missed this
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)