This bellhousing was used in the Kurtz SU/AIX car: http://www.frrax.com/rrforum/index.php?showtopic=14181&st=0&start=0 between a LS3 and a LT1 T56 using a McLeod clutch and flywheel. I had to trim some in the starter and slave areas, which may have voided the SFI rating.
asking $300
Here are the McLeod part numbers:
bellhousing 8760-00
thowout bearing 1400-22
clutch 651052-00-07
I used ARP-330-2802 flywheel bolts
when it was new:
bellhousing was almost sold, we took some measurements and it's not going to work with a LS T56 without some spacer fab.
So, still available, specifically for mating an LT1 T56 to a LS motor.
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)