 Stainless wire mesh screen, where do you get yours? |
|
|||||||||
  |
 Feb 2 2004, 10:25 PM
Post
#1
|
|
|
Veteran Member  Group: Member Posts: 2,688 Joined: 23-December 03 From: Ft Worth, TX Member No.: 8  |
i've been looking for a good place to get this stuff, but havent had any luck. i found it @ one place online (Pegasus) but its a little on the high side. any other alternatives? i need a section 7"x33".
|
 |
 
|
|
Feb 3 2004, 02:02 AM
Post
#2
|
|
|
Experienced Member Group: Advanced Members Posts: 1,042 Joined: 24-December 03 From: Hanover, PA Member No.: 36 |
http://www.bsrproducts.com/productframe.html
Go to "Screen Wire" They have SS wire. Looks good and works well. I used it to shield my brake ducting inlets. steve |
|
|
|
|
Feb 3 2004, 02:35 AM
Post
#3
|
|
|
Advanced Member Group: Advanced Members Posts: 902 Joined: 27-January 04 From: Magnolia, Tx. Member No.: 160 |
Does it have to be stainless? I've been using the galvanized stuff you can find at places like Ace hardware, and its worked fine.
|
|
|
|
|
Feb 3 2004, 02:42 AM
Post
#4
|
|
|
Veteran Member Group: Member Posts: 2,688 Joined: 23-December 03 From: Ft Worth, TX Member No.: 8 |
i would prefer stainless, but i have found the galvanised stuff and it is much cheaper.
i've made a frame for a screen that blocks the opening above the airdam to the radiator and condenser. i have a nice radiator from LG's now, and i don't wana run the risk of getting it punctured. it will not be seen, thats why i have considered galvanised, but i like knowing i didnt skimp on quality when i made it. that stuff @ BSR - is it 36"x36"? it only gives the opening dimention and width. |
|
|
|
|
Feb 3 2004, 03:10 AM
Post
#5
|
|
|
Experienced Member Group: Advanced Members Posts: 1,947 Joined: 23-December 03 From: Everett, WA Member No.: 16 |
IIRC, the width is fixed but you can buy it in any length you want (it'll come in a roll). The stainless is nice, never rusting, etc.
|
|
|
|
|
Feb 3 2004, 01:47 PM
Post
#6
|
|
|
Veteran Member Group: Member Posts: 2,688 Joined: 23-December 03 From: Ft Worth, TX Member No.: 8 |
what is better, welded or woven?
|
|
|
|
|
Feb 3 2004, 08:02 PM
Post
#7
|
|
|
Advanced Member Group: Advanced Members Posts: 813 Joined: 21-January 04 From: Santa Barbara, CA Member No.: 141 |
|
|
|
|
|
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:
| Lo-Fi Version | Time is now: 5th May 2025 - 01:42 PM |