IPB

Welcome Guest ( Log In | Register )

Blaine Fabrication.comUMI PerformanceHotpart.comSolo PerformanceUnbalanced Engineering
 
Reply to this topicStart new topic
> FISKE FM5's cheap, FISKE FM5's cheap
bills
post Apr 6 2004, 03:08 PM
Post #1


Member
*

Group: Advanced Members
Posts: 96
Joined: 20-March 04
From: boxford MA
Member No.: 280



One pair of FIKSE FM/5 16x9 wheels. I’ve recently picked up a sets of FIKSE FM/5 wheels from a local road race team. The wheels were used on LS1 and LT1 Firebird and Trans Am cars. These could be used for road, autocross, and drag racing (Drag radials or slicks). These wheels have been used for a few race seasons so they will show some typical wear (scratches and dings) from numerous tire changes. This pair is 16 inch diameter by 9 inch wide with a 7 inch backspace. I checked the backspacing on a stock 16x8 wheel and it measured at 6 ¾ inches. They weigh in at 15.5lbs my bathroom scale compared to 18-22lbs for the stock wheels.Please note the small ding on one of the wheels near the valve stem. It is very slight and does not effect them.
I have was going to use them for ET streets but was just given some Draglites. they are very light and look good( lots of cleaning was done) They cost 1500 new for the pair asking 400+ shipping or BO
Go to the top of the page
 
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: 5th May 2025 - 03:43 PM