F-Body Road Racing and Autocross Forums > Lower Trailing Arm Relocation Bracket advice

Full Version: Lower Trailing Arm Relocation Bracket advice

F-Body Road Racing and Autocross Forums > Community > General Discussion

1997TA

Mar 10 2010, 05:32 PM

I have 97 TA and installed bolt-on lower trailing arm relocation brackets. I already had lowering springs and Koni SA/DAs. Problem is, I now have a wobble/vibration coming through my seat at speeds above 90mph. I am not sure if the vibration was a result of the bracket install. Is an alignment recommended after changing brackets? I was thinking that it might just be "time" to balance my aluminum drive shaft again?? Any thoughts greatly appreciated.

NJSPEEDER

Mar 12 2010, 05:47 AM

Check to make sure the rear is centered and square. If it is slightly off it can cause that problem.

-Tim

c5z28

Mar 12 2010, 07:36 AM

QUOTE (NJSPEEDER @ Mar 11 2010, 09:47 PM)

Check to make sure the rear is centered and square. If it is slightly off it can cause that problem.

-Tim

Via lower control arms if they are adjustable?

This is a "lo-fi" version of our main content. To view the full version with more information, formatting and images, please click here.