Moser 12 bolt:
-Eaton HD with Toms Differentials upgraded spiders supposed to be stronger than the usual upgraded spider. I only broke the originals, these have been in the diff since 2005.
-33 spline axles New in 2008
-ARP studs 12mm
-HD Aluminum Girdle cover with preload studs
-3:73 gears Gears, fresh bearing and seals 2010. 3-4kms tops.
-set up for four channel ABS
-1350 pinion yoke
-Includes the backing plates for the rear brakes.$400
-weld in relocation brackets $100
-Spohn sway bar installation kit $75
New price for above is $3339 + shipping and taxes.
1 Full Throttle Welding long Torque Arm. Chrome Moly with Rod ends and Urethane bushings, comes with a cross member for a 6spd. A really nice piece. New price $550 approximately
1 Spohn Short Tunnel mount Torque arm with DS loop. New $415
1 Fayes Watts Link modified to fit (shims and machined pivot hat, drilled out axle clamp for vent) with a 12 bolt with the HD cover. $650
Totals for $5008 if bought new not including taxes or shipping.
$2800 takes the whole kit including the backing plates, if you want to use your backing plates, I will knock off $200. It will be a lot easier to make it a bolt in though and you could sell you backing plates for at least $200, they are $400 new.
I will have to get pics of the long and short TAs.
Let me know if you are interested. My new one will be a couple months. BTW it is a Midwest Chassis 9" with a Watts link.
Might be willing to discuss the driveshaft too, it is a steel one with 1350 Spicer yokes and upgraded HD U joints.
I am in Canada, but only about 35 minutes from Niagara Falls New York. Meeting Windor Ont is also a possibility.