Nearly complete TPI set-up reduced to $300


Polished TPI runners $75


GM Performance Flywheel reduced to $100
http://www.summitracing.com/parts/NAL-14085720/
15 lbs, only 3lbs heavier than an aluminum Fidanza. Comes with Grade 8 bolts.


Moroso Polished Aluminum Valve covers $85 sold

Classic Industries Floor mats for 3rd gen reduced to $75


2460 Hooker Shorties sold

Set of 12 Stock Grand National Injectors, I need to check the PN and flow rating. $25 shipped


749 Syclone / Typhoon ECM reduced to $60 shipped


730 ECM reduced to $30 Buy and keep as a spare


Scan Guage II, only used a couple times. sold

Joe's racing shifter for Jerico or T10 or similar $60
8" with 3" set back

Set of coils removed from a 99 LS1. One coil is damaged and will need replaced but the rest are in good condition.

$60 shipped Sold

Price on the Hooker Shorties? Do you have a Y-pipe?

Just sold the shorties today. Sorry

Will the Scangauge work on OBD1 cars? (like my '91 Corvette) I'm guessing not....

I think it is obdii only

You are correct.

What did you think of it - I'm kinda interested in it myself.

We only used it a couple times at work because we were working on an efficiency project and the vehicle we had didn't have the displayable mpg built in. Beyond that I didn't use it for anything else. It was straightforward and easy to use as I recall. I also have it listed on eBay now, didn't think people here would be interested.

If you can cancel the auction, I'll take it. If not, then no biggie.

It could come in handy as a code scanner, if nothing else.

ScanGuage is pretty nice if you don't trust the factory idiot lights, I mean gauges. Nice to be able to clear codes too. I'd be in for it if I didn't already have one.

On the 4th gen LS1's ECM, is oil pressure a reported/supported PID that would show up, or be readable by this Scan Gauge??

Its up to 90$ already so I'll keep the auction. Another one just sold for $122. If you want to work something out offline PM me.

http://www.ebay.com/itm/271013483709?ssPag...984.m1555.l2649

No thanks

I updated the first post.

I think I may have to have the shifter.... shipping to 43123? My Muncie could use a cool shifter to go along with straight cut gear whine...

$7 should cover it. Paypal austingerding at Hotmail dot com or I can PM you my address if you want to send a check.

It is a pretty cool shifter with some amazing machining on the ball. My only complaint is my hand would hurt a bit after banging the gears for a while, but if you have synchros you want be shifting so hard.

updated prices

part number/flow rating on injectors?