I am parting out what is left of a '99 Z28. More parts will be added soon. Thanks, Greg

Braille battery part#B14115 with aluminum bracket ($225 new) $130 shipped SOLD


Momo 350mm "race" steering wheel (new $230) $150 shipped SOLD


1.75" DOM .120 wall X-brace kit & gusset kit ($200 invested) $115 shipped


Jegs ignition panel & 4 post battery disconnect switch $50 shipped


Autometer brake pressure gauge(#5426), fittings, and 3an braided steel line ($150 invested) $60 shipped
Autometer oil pressure gauge(#5421), low pressure warning light, fittings & 3an braided line ($220 invested) $60 shipped (the bezel is bent at the bottom)


Blaine fire ext mount for 1.75" roll bar $65 shipped


Unknown brand bump steer kit $30 shipped

Will you also be selling the front sway bar?

I was going to sell the front bar until I realized it is bent about an 1/8" end to end. I may just put it on my car and sell the older 35mm I have been using. I will let you know. Thanks

PM sent regarding sway bar brackets

I will take all the ARP bolts and whatever else Alan Blaine thinks my build could benefit from. I have Blaine's front sway bar brackets. I thought that Strano's adjustable bar came with rear sway brackets or did you also need Blaine's brackets for the rear?

Interested in the pedals. Do you have any pictures?

GNBS is my buddy, buy with confidence.

Sorry, I will get the rest of the pics up asap. Here are the pedals:

Price shipped to 41094 for rear sway bar please??

Sway bar has been sold, thanks.

I may be interested in that oil press. gauge. What is the length of the hose? Thanks.

The hose is 36". The adapter goes in place of the factory OP sending unit, and the hose has some slack when mounted where the radio was. Thanks

Does the Blaine PS cooler come with mounting hardware?

Yes, the mounting bracket is attached to it. You can either bolt or pop rivet it to lower radiator mount.

Thanks. I'm interested. Let me double-check the hole in my dash where the current gauge is. I'll hopefully get time this afternoon to check.

Updated list.

What would it take to get the steering wheel mounted? Sorry for the dumb question, I have not messed with steering wheels...yet.

A Momo model# 2401 adapter, which needs to be machined about 1/8" on the back (towards dash) side to fit flush/properly with the column cover trim when the hub bolt is hunkered down to the correct torque.

You will need a way to turn out the AIRBAG dash light, either with a BCM 'write out' (IF that is even possible??), a resistor in the yellow SIR connector (forgot the ohm rating), or a piece of black electrical tape over the light inside the instrument bezel.
(This is IF your state even checks for/cares about this light at all, on a street legal/driven car. )

I have a suede Sparco mod 383 in my street driven car, and I could not even imagine going back to that P.O.S. stock wheel EVER.
It was the very FIRST thing I did to this car when I got it home from the dealer, brand new, in January '00.

Wow thanks a lot. KY does not do yearly inspections nor do they do safety checks lol. So I won't have to worry about that. My issue will be if I want to run a wheel without an airbag on a DD.

Yeah, MANY people will lambaste me for doing that, but I ALWAYS wear the OEM 3 point belt, and then I ask them, "what oh WHAT did people EVER do before the 'exploding pillows' were in every car??"

(I ask the same of those who are NEVER off of their smart phones. )

Off topic but:

http://www.autonews.com/article/20150130/O...-autonews-daily