For Sale:

Stoptech brake kit PN 83.183.4600.71







I have been EXTREMELY happy with these brakes but I'm switching to a different wheel and tire package so I'm selling these. I used these with Hawk DTC 70 pads with a manual brake setup with a 3/4 master cylinder. These are on my time trial camaro built to AI rules. I don't like to compare to other cars braking ability (driver skill/balls comes into play here) but I could brake with most everything I was on track with.

Included is the full brake kit with ST-40 calipers, new racing brake rotors 2 weekends old (almost no wear), hats, radial mounting brackets and a spare set of rotor rings. The spare set are the originals I changed out slightly early because a couple of the heat checks were getting a bit deep but do not appear to have gone through the rotor surface and have not propagated to the edges. The entire brake setup is in great condition functionally and good condition cosmetically. I rate these good only because they have been used so there's the normal buildup around the bleeder valves, brake dust in the hard to reach areas and possible tire booger streaks. The banjo fittings come with the calipers but the lines do not. A set of DTC 70 pads also comes in the calipers with approx an 1/8" of material left.

$1200 plus shipping

Does this kit require modification to the spindle, like the C5/6 kits?

I see brake ducts, do they come with spindle ducts? How many sessions on the rotor shown?

Fit under 17 inch wheels?

Sorry for not updating this sooner. These brakes were sold approximately a month ago.

To answer the questions though; 98-02 spindles require no mods; the rotors had 2 weekends, about 17 sessions with hawk dtc70 pads and yes, they fit under 17" wheels. I ran them with zr1/ss wheels with a 1/4" spacer.