ALL IS SOLD-THANKS!!!

I can't remember, are 1 and 3/4" recommended for stock 346 block size or only if you've gone with bigger cubes? Are you running stock engine size?

Also just wondering, how did they get bent? You said you haven't installed?

1 3/4 is recommended for stock cubes. 1 7/8 I believe was for bigger cubes, and stepped headers for FI applications. The LT's are not bent, at the opening of one of the y-pipe pieces it is slightly bent in, like if you dropped a piece of pipe on the ground, and the opening hit first. Its not bad, but I though I would mention it.

And I sincerelt apologize for not responsing sooner, the email notification didnt notify me

When buying long tubes what you are paying for is fitment, quality, fit and finish. All LT's dyno within the same net gain. Swap from one brand to another for the sole purpose of gains and you'll be disappointed. 1 3/4 sized primaries are more then adequate for stock cubes. If you have a stroker look into some 1 7/8 primaried headers. If you have a high power stock cubed setup you might want to look into a 1 ¾ stepped to 1 7/8.


Thats off of LS!tech.com, under one of JRP's stickies.

Updated package price deal. TTT.....

Hey all, I lowered the package price. If anyone is local to me (Fredericksburg, VA) I wll cut you a sweet deal. PM me.

TTT>>>>>>>>>>>>> Prices lowered!!!!!!!!!! These headers are brand friggin new, and have absolutely nothing wrong with them.