I'm getting tired of looking at some of this stuff in the basement. I sold a ton of stuff (mostly on LS1tech) when I first gutted the car, but some things are lingering. I'm flexible on prices, but I need to get actual shipping costs. I'm sure there are things I forgot, so just ask if you are looking for something.

********************************************************************

All of these parts have between 1,000 and 31,000 miles on them, most engine/suspension have less than 10,000 miles except A/C has about ~27k miles. My zip code is 08822. Most parts are stock, unless noted otherwise. I accept Paypal.

Swaybars - $30 + shipping

Spare Tire/Jack - $40 + shipping

Upper Airbox - $25 + shipping

Oil Cap - $12 shipped

Camshaft - $35 + shipping

Pushrods - $15 + shipping

Cargo Tray Cover - $20 + shipping

Air Pump w/hoses - $55 shipped

Upper Dash - Offer

Gauge cluster bezel - $15 + shipping

Exhaust Manifolds and Cats - Offer

Y-pipe - $30 + shipping

SLP Y-Pipe (Stainless Steel) - $90 + shipping

Door handle trim pieces - $25 shipped

Door sills - $20 + shipping

Windshield washer tank - $20 shipped

Driver/Passenger Airbags w/sensor, module and clockspring - Make offer

Passenger side seat belts (front) - $50 shipped

Steering Wheel Radio Controls - $30 shipped

Steering Wheel - $25 + shipping

Rear-end cover - $25 shipped

Rear-hatch release motor - $20 shipped

Hood (Arctic White) - $125 o/bo (local only)

Front upper and lower control arms - Make Offer

Stock Z28 Springs - $20 + shipping

RCI Universal SFI Tranny Blanket (New) - $80 shipped

I also will have windshield and rear glass over the next few weeks.

75%+ of the parts are gone...most of the big ones too!!! Thanks All!! Just a few more items to go.

-Dennis

I might be interested in those wheels... need to do some finances inspection. =)

What does the set of control arms weigh altogether (for shipping)? What alignment specs were you getting before they came off? Are they on the less than 10K list?

Just keep in mind the shipping costs of wheels and tires. I was hoping for a local on them, just to keep the costs more sane.

Sean-

They are off the list of 30k miles. About 28k street miles, and 2k track miles (1/2 street tires/ 1/2 track tires). I think I maxed them out around -.75 or so IIRC? I really don't know what they weigh. If you are serious, I could try and weigh them.

-Dennis

Yeah I'm aware, if I can swing them, I'll most likely make a road trip for them. (My girlfriend goes to West Point so I have plenty of reason to be in the area... )

Cool. I'm not in a rush, let me know if and when you are ready.

What's shipping on just the spare tire to 40220? I need a spare since mine won't fit with LS1 brakes.

I used a rough 35 lbs. and 27" x 27" x 8" and it came to about $25 for shipping. Figure $25 for the tire.

$50 total?? Assuming I could just tape up some cardboard around it.

The cargo tray cover, you're talking about the piece that closes off the area between the back seat and the "trunk" cavity?

If so, I'm interested, also interested in the two trim pieces that it sits on, if you have them.

Also, how much for just the rear sway bar?

Thanks. John

The RCI trans blanket...what is it made of? Does it fit nice on a T56? I am looking for something in case of a clutch explosion, I don't want any injuries in my car! I have seen something similar made of kevlar sold by Thunder Racing...is this something similar? If so I am interested.

John-

Yes, the piece that closes off the back seat/trunk area. PM me your zip.

I'd like to sell the swaybars together....since they already packaged up from someone else who backed out a few months back.

-Dennis

It is the same one that is on Thunder's website:



RCI's universal transmission blanket is water and oil resistant, and is made of high-tensile webbing and steel. It is 47 in. x 11 1/2 in., has an SFI rating of 4.1 and fits most transmissions. NHRA rules require any automatic transmission equipped car running 10.99 or quicker (or faster than 135 mph) must be equipped with a transmission shield or blanket-type shield with a SFI rating of 4.1.

---------------------------------------------------------------
I'm not going to lie....I bought it to put on when I did my clutch last winter, and I was having a hard time getting it on with the tranny in the car. Supposedly it fits, and it probably does (as other LS1 vendors also sell them too), but I bailed out on it. Figured drag race guys blow clutches b/c they slip the shit out of them at high rpm launches. RR seems to be a lot easier on clutches.....if you know how to upshift and heel & toe downshift.

But....I'd be more than happy to sell it to you. It is new (just a few scuffs of dirt on it from trying to put it on).

Dennis, my zip is 93555. Do you have the two rear trim pieces that go back there, or are they staying with the car?

I can do it for $40 shipped. The other trim pieces were sold about a year ago....sorry.

I was actually thinking of this one: http://www.exoticmuscle.com/webpage.php?EM...S&CATSEL=SAFETY

p/n F6800. I think it is made especially for the T56 and mounts with the bellhousing bolts. I just wondered if you knew how this one compared. I appreciate your honesty!