[StanIROCZ]

I'm hoping someone has a 4L60e torn apart and sitting in a box in the corner of their garage somewhere.... Or maybe you know someone that does?

I need a couple parts:

40 tooth tone ring - It's pressed onto the outpshaft of the trans. Probably pretty tough to get off, so if you want to send me the whole shaft that's cool.

Vehicle Speed Sensor - It's located in the passenger side of the tail housing.

These parts can be found in 1993 and newer 2wd trucks and 1994 and newer rear drive cars.

This is a long shot but I'm also looking for a DRAC (digital ratio adapter controller) from a 89-94 S10, Astro Vans, and 90-95 full-size trucks. The VSS is wired into this and it conditions and applies a ratio to the signal that goes to the speedo and ECM.


Thanks, Stan

This post has been edited by StanIROCZ: Apr 23 2008, 09:42 PM

[trackbird]

I have one of the speedo calibration boxes you are looking for. I forget who's, but it's one. I used to have one that just had a knob on the side (a small pot you adjusted with a set screw), but it's long gone. The current car has one that uses dip switches to set the ratio. It's currently in the car, but it may not be there much longer. Let me see what my plans are and I'll put you at the top of the list for it.