[StanIROCZ]

I'm hoping someone has a 4L60e torn apart and sitting in a box in the corner of their garage somewhere.... Or maybe you know someone that does?

I need a couple parts:

40 tooth tone ring - It's pressed onto the outpshaft of the trans. Probably pretty tough to get off, so if you want to send me the whole shaft that's cool.

Vehicle Speed Sensor - It's located in the passenger side of the tail housing.

These parts can be found in 1993 and newer 2wd trucks and 1994 and newer rear drive cars.

This is a long shot but I'm also looking for a DRAC (digital ratio adapter controller) from a 89-94 S10, Astro Vans, and 90-95 full-size trucks. The VSS is wired into this and it conditions and applies a ratio to the signal that goes to the speedo and ECM.


Thanks, Stan

This post has been edited by StanIROCZ: Apr 23 2008, 09:42 PM

[StanIROCZ]

I've visted a salvage yard the past couple days at lunch and was able to salvage a DRAC and a 3rd gen non-electric hatch latch, and another eletrical connector that I needed. I'm still looking for the VSS, connector, and ring.

Curiously there was 2 TPI f-bods with what looks like complete or near complete harnesses. Those go for around $150 on ebay last I checked. I'm going to see what the yard will sell them to me for.

I also saw a 60's Mustang that I'm going to check out more closely next time. Forget about making it a gem, if nothing else that'd make a cool AIX car (I'm thinking of the green one that I saw at Nationals). All you need is the stock floor, firewall, and front towers too be legal. Maybe I'll take some pics next time.