[StanIROCZ]

I'm hoping someone has a 4L60e torn apart and sitting in a box in the corner of their garage somewhere.... Or maybe you know someone that does?

I need a couple parts:

40 tooth tone ring - It's pressed onto the outpshaft of the trans. Probably pretty tough to get off, so if you want to send me the whole shaft that's cool.

Vehicle Speed Sensor - It's located in the passenger side of the tail housing.

These parts can be found in 1993 and newer 2wd trucks and 1994 and newer rear drive cars.

This is a long shot but I'm also looking for a DRAC (digital ratio adapter controller) from a 89-94 S10, Astro Vans, and 90-95 full-size trucks. The VSS is wired into this and it conditions and applies a ratio to the signal that goes to the speedo and ECM.


Thanks, Stan

This post has been edited by StanIROCZ: Apr 23 2008, 09:42 PM

[Racerdad916]

Dad couldn't find a tone ring in the shop. He was going to look in the building where the cores are and let me know. He thought he could get it through Transtar (our trans parts supplier). I will let you know when I hear from him. Are you using a 4l80e in something?

[StanIROCZ]

Dad couldn't find a tone ring in the shop. He was going to look in the building where the cores are and let me know. He thought he could get it through Transtar (our trans parts supplier). I will let you know when I hear from him. Are you using a 4l80e in something?

Thanks for the effort. I'm putting in a Jerico 4 speed and it doesn't have any such speedo device. I was planning to not run a speedo at all, but I'm finding out that I'm going to have big problems with the ECM without it.

The easiest way I'm finding to rig up a VSS is to use the 40 tooth tone ring with the 15547452 sensor that I mentioned above. I've looked at adding a tone ring to the ring gear in the axle or a wheel speed sensor like the 4 channel abs on 4th gens but the speed is too slow. Also looked at adding a tone ring to the pinion flange. I think the best way is going to be to add the 40 tooth ring to the trans output shaft, so thats what I'm planning to do.