[Sam Strano]

I'm now happy to announce we can take pre-orders on a Watts Link for all 82-02 F-bodies with stock diamter axle tubes. There is a version for bigger axle tubes (suck as 12-bolts, etc.) in the works.

They should be ready to ship in approximately 2-3 weeks. The unit is made by Fays2 who has been doing these for Mustangs for more than a few years. I not only trust the unit and have had all my questions answered, but will be putting one on my car as soon as possible. Jim and I have had a few discussions about the design and I'm happy to say he addressed my main concerns regarding approximate roll-center height. I wanted to make sure we could start @ stock height and adjust down as the owner sees fit. That has been done and implimented in this unit.

Details, specs and a photo on a 4th gen can be seen here:
http://www.stranoparts.com/partdetails.php...7&ModelID=7

(IMG:http://www.stranoparts.com/data/images/p30617181655.jpg)


Price is $650 Plus shipping. Shipping costs will normally not exceed $30 in most cases.

Fays2 own website has the pricing set lower, but after a discussion with Jim Fay, he informed me the prices are incorrect and will be changed.

[Sam Strano]

And the latest update.........









Starting to ship out today. There is an aluminum spacer that wasn't completed on time. Fays2 is sending those out at their cost by 2-day air when they arrive (due next Tuesday). Because these are shipping ground freight the spacers and Watts Links should arrive at just about the same time.

[sgarnett]

Mine arrived today. The instruction book is very thorough, with lots of color photos.

The axle clamp/brackets seem to be sized for a 9" and/or 12 bolt, and there are split-tube steel shims included to presumably fit the smaller 10 bolt axle tubes. That's the one obvious detail missign from the instructions.

Also, the instructions specify reinstalling the passenger-side PHR and PHR brace bolts, installing the nuts loosely with Loctite, reinstalling the driver-side PHR brace bolts with Loctite, and then torquing them all. Personally, I'd just install the passenger side bolts but leave the nuts off or just temporarily thread them on dry and loose, then install and torque the driver-side bolts with Loctite, and then install and torque the passenger-side nuts with Loctite.

This post has been edited by sgarnett: Sep 4 2008, 12:34 PM

[Cr0usEEE]

I got mine yesterday...and gone through the instruction manual before installing tonight. I have two questions.

1) What spacer is required for the "stock" rear sway bar? (1st page in manual)
2) It does not specifically say...but should the rear axle/car be on the ground during install?? I mean have the rear up on ramps instead or supporting the car on jack stands from the frame rails. My impression is that ramps is the ticket but it is not called out in the instructions.

[shortbus]

I got mine yesterday...and gone through the instruction manual before installing tonight. I have two questions.

1) What spacer is required for the "stock" rear sway bar? (1st page in manual)
2) It does not specifically say...but should the rear axle/car be on the ground during install?? I mean have the rear up on ramps instead or supporting the car on jack stands from the frame rails. My impression is that ramps is the ticket but it is not called out in the instructions.

It does not say drive on lift preferred?