[mitchntx]

IN an effort to lose weight off the race car, I want to cut the SFCs off. However, I use them to jack up the car.

After seeing several "pro" teams use a receiver/stab setup off the roll cage, I began fabricating this kind of rig.

I used 1" square tubing as the receiver and gusseted the hell out of it to keep deflection to a minimum. I have some 3/4" solid bar stock I was using as the stab.

After welding the receiver portion to the cage and mocking up the stab with plenty of gussets, I tested the rig and ... it bent. (IMG:http://www.frrax.com/rrforum/style_emoticons/default/mad.gif) 3/4" solid bar stock bent like a pretzel.

And it yielded right at the end of the gusseting. Think of it as a pry bar.

I opened the door and placed the jack on the end of the receiver and lifted the car without an issue ...

So help me out here ... what can I do to the bar stock I have to increase it's strength or what kind of 3/4" bar stock can I source that will lift 1500lbs?

[nape]

You can accomplish the same thing with about 8" of 1 1/4" schedule 80 pipe per side (or at least that's what I think it is. I found it on a job). I'll see if I have any pictures of it at home.

Make a 6" wide x 2" high T out of the pipe and weld it to the rocker panel and floor pan right underneath the rear most of the two floor pan seat rails. It jacks the car almost perfectly.

They maybe weigh a pound each?