![]() |
|
![]() |
![]()
Post
#1
|
|
Experienced Member ![]() ![]() ![]() Group: Advanced Members Posts: 1,197 Joined: 13-February 04 From: Hudson, Colorado Member No.: 197 ![]() |
I've done so much car work in the last 2 weeks, I'm actually getting sick of it. Here's the list of what I've had to do.
'88 Buick: PS Pump - leak and bad bearing Harmonic Balance - rubber cracked and pully delaminated Passenger side half shaft - outer CV boot exploded '03 Jeep Grand Cherokee: Front brakes and rotors Inner front axle seals - passenger side was leaking and may have been the cause of the brake issues Transfer case fluid change - it was just time Passenger front window regulator and motor - cable broke I've got about $750 in just parts, I don't even want to know what all this would have cost at service shops. Anyway, just venting. |
|
|
![]() |
![]()
Post
#2
|
|
Advanced Member ![]() ![]() Group: Advanced Members Posts: 461 Joined: 24-December 03 From: Orlando, FL Member No.: 34 ![]() |
I had an 02 Saab 9-3 convertible heater hose replacement kick my ass this past Saturday but damn Kevin it pales in comparison to what you went through. I've got a steering rack for the Trans Am, front passenger side lower control arm and a headlight bucket sitting there for my 07 Yukon. I'm so pissed off at a 44,000 mile 07 Yukon needing a control arm and headlight bucket that I haven't been able to bring myself to work on it. GM build quality sucks!
|
|
|
![]() ![]() |
Lo-Fi Version | Time is now: 8th July 2025 - 01:26 AM |