[trackbird]

If you've wanted to do the trackbrackets C5 or C6 conversion, this is the lowest price we've ever offered on these. If you think you might buy a 4th gen in the future, you might want to put a set on the shelf for a rainy day.

Trackbrackets C5/C6 (C6 Z51 and C6 Z06) conversion brackets with bolts (you'll still need the calipers, PAB's, pads, etc. Feel free to ask questions if the sticky doesn't answer them for you).

$130 shipped in the 48 states. If you buy 2 sets, I'll knock that down to $120 a set (and no paypal fees on either price).

Thanks!!!

[sgarnett]

My approach to avoiding stress risers was a smooth cut (IMG:http://www.frrax.com/rrforum/style_emoticons/default/smile.gif)

I marked my cut line, used a cutoff wheel to start it at the right angle (since a saw blade will just walk if it isn't close to perpendicular), then switched to a Sawzall with oil to complete the cut a lot faster (consuming one fresh blade per side). I used an angle grinder to smooth and deburr the cut.

I may have followed that up by hammering the cut surface with a ball peen hammer, but I'm not positive.