[RegaMaro]

What's the next part you're buying? Suspension, driveline, motor, cup holder?







Next thing I'm buying is a set of file fit moly rings from either Albert and childs or Speed Pro.

[John_D.]

Mostly piddly stuff to finish the prep work on the LS1, for the v6 to v8 swap. Need to get these items picked up in the next few days:
* Front tranny seal before I put the converter, tranny, and engine back together.
* Hi-side ps hose, since the one on the swap engine is crimped in one of the bends.
* Tranny filter and fluid to refill it after putting the shift kit in. Rear seal too.
* Maybe starter and/or alternator. Every other rotating piece on the outside was shot.... Pulleys, water pump, etc. So the alternator and starter are suspect too.

Stuff I ordered/picked up just this week:
* one motor mount (the right one was bent)
* pressure bleeder for brakes
* reservoir cap pre-tapped for fitting for pressure bleeder
* adapter for 5 wire maf to 3 wire maf + 2 wire iat
* alignment turnplates
* air block off plates for the MAC headers.


That reminds me, I have a 255lph fuel pump to put in too. Gotta replace that v6 pump....

Anybody have any leads on a nice cover plate I could put back over the hole I'm going to cut out over the fuel pump? I could make one, but if I could get something universal, I'd look into that. Especially if it had a sealing door....



Later this year, a 6pt bolt-in roll bar. Possibly a lightweight battery.