[StanIROCZ]

Suspension Spring Specialist 5.5x8 800 lb/in springs (3rd gen front, and others):
(IMG:http://i116.photobucket.com/albums/o33/StanIROCZ/For%20Sale/DSC00020.jpg)
$80 shipped $60 shipped

Suspension Spring Specialist 5x9.5 200 lb/in rear pig tail springs:
(IMG:http://i116.photobucket.com/albums/o33/StanIROCZ/For%20Sale/DSC00021.jpg)
$80 shipped sold

3rd gen rear Koni shocks with ~5k miles still in original box:
(IMG:http://i116.photobucket.com/albums/o33/StanIROCZ/For%20Sale/DSC00015.jpg)
$200 shipped. Best mod you'll do to your car. SOLD

[StanIROCZ]

1200 lb/in 5.5x9.5" springs:
(IMG:http://i116.photobucket.com/albums/o33/StanIROCZ/For%20Sale/DSC04251.jpg)
These likely won't work with off the shelf Ground Control weight jacks because they are too tall for the stiffness.

$50 shipped or donated for the cost of shipping to a Lemons team. sold

[trackbird]

1200 lb/in 5.5x9.5" springs:
These likely won't work with off the shelf Ground Control weight jacks because they are too tall for the stiffness.

$50 shipped or donated for the cost of shipping to a Lemons team.

Stan, are these the slightly "mis matched" pair? And, how much needs cut off to make them work with GC stuff (any idea). Then we can calculate the new rate. Just curious.... (IMG:http://www.frrax.com/rrforum/style_emoticons/default/loco.gif)

[StanIROCZ]

1200 lb/in 5.5x9.5" springs:
These likely won't work with off the shelf Ground Control weight jacks because they are too tall for the stiffness.

$50 shipped or donated for the cost of shipping to a Lemons team.

Stan, are these the slightly "mis matched" pair? And, how much needs cut off to make them work with GC stuff (any idea). Then we can calculate the new rate. Just curious.... (IMG:http://www.frrax.com/rrforum/style_emoticons/default/loco.gif)

Yes, they appear slightly mismatched. I bought them as a pair off ebay and the seller checked the rates using a spring tester, and engraved the rate on the bottom of the ground flat coil. IIRC the # of coils and wire dia is slightly different but possibly offsetting. Whatever differences are in these springs I doubt you’d ever notice.

As far as how much would need cut to fit in a GC set-up I don’t know for sure since it’s been so long since I figured that out. My guess right now might be ½” but no more than 1”. I remember it being borderline. I’d probably try installing them first with the GC set-up full low and see what the ride height is then go from there.