[Blainefab]

Announcing the Blaine Fab power steering cooler package - this package has been race proven on the Blaine Fab ITE 4th gen, and many AI and CMC 4th gen cars.

Easy install with a drill, pop riveter and screwdriver. No cutting on LT1 cars, uses existing hole in the radiator shroud. LS1 cars require cutting a hole in the plastic shroud.

Package includes:
B&M stacked plate cooler
pipe to -AN adapters
-AN hose ends
Goodyear power steering hose
aluminum bracket, predrilled and attached to cooler
pop rivets for attachment to shroud

Cost is $145 + CA sales tax for deliveries in CA, + shipping

add 2qt of Redline Power steering fluid for $24

(IMG:http://www.blainefabrication.com/projects/2010_04_02/IMG_3383.JPG)

This post has been edited by Blainefab: Mar 26 2015, 12:53 AM

[Libertyforall177...]

LS1 Camaro: Am I meant to attach the cooler to the plastic shroud bottom, or to the metal frame beneath that? It is not too clear where it should attach. Also, is the plastic shroud enough to hold the cooler in place by the bottom only, or do I attach somewhere near the top as well?

TIA

(IMG:http://i.imgur.com/Ru7SNMZ.jpg)

This post has been edited by Libertyforall1776: Apr 28 2015, 12:59 AM

[Blainefab]

LS1 Camaro: Am I meant to attach the cooler to the plastic shroud bottom, or to the metal frame beneath that? It is not too clear where it should attach. Also, is the plastic shroud enough to hold the cooler in place by the bottom only, or do I attach somewhere near the top as well?

TIA

The cooler bracket goes under the bottom edge of the plastic shroud - my pics are down right now, but Steve posted a pic of his install on a LT1 car, a couple of posts up. The LS1 install is very similar - same place. The template wraps around the bottom corner of the shroud, mark and cut the hole with a dremel or knife, hold the cooler in place and mark the holes thru the bracket. Drill parallel to the face of the radiator, do not drill into the radiator.

Once the cooler is attached at the bottom and the hoses are routed, zip tie the hoses to the fan shroud to support them from flopping around. This is all
the support that the cooler needs.