[robz71lm7]

It can be viewed here:
http://www.jegs.com/webapp/wcs/stores/serv...11919&langId=-1

Any thoughts on the effectiveness? I've never seen one up close so I can't tell a whole lot about it. I already have a Grant Formula 1 wheel and can get this lock cheap.

[robz71lm7]

I'm not Bill and I have a 4th gen so take it for what it's worth...

My wheel is now further away from me compared to when it was just attached with a standard Grant adapter. I have to verify this with grant but you might be able to attach one of their 1 or 2" spacers to it in order to move it closer. I have a pic of the cheap stamped steel version below. I used adapter #3021 which is shown in Bill's link. It's pinless and SFI approved.

Ignore how dirty the car is I've been busy:

(IMG:http://www.robmeadway.com//IMG_1135.jpg)

(IMG:http://www.robmeadway.com//IMG_1124.jpg)

(IMG:http://www.robmeadway.com//IMG_1125.jpg)

(IMG:http://www.robmeadway.com//IMG_1128.jpg)

(IMG:http://www.robmeadway.com//IMG_1130.jpg)

Amazingly I was thinking to myself I'd need a horn for autocross. Last year there was a cone in the middle of the finish on course at one event. I came to a stop like I should pointed and yelled and sat for what seemed like 15 seconds but the corner workers were sleeping. I ended up having to take off (another car on course) and wasn't able to get a re-run since the workers said they hadn't seen anything. (IMG:http://www.frrax.com/rrforum/style_emoticons/default/rant.gif) That's a good use for the horn. (IMG:http://www.frrax.com/rrforum/style_emoticons/default/wink.gif)