coilover and pigtail springs, spring cleaning in process Options

[fast ken]

Alan- Do you have any rear spring shims for sale? I need to shim up both sides approx 3/4" to 7/8" on my LT1 car. I could use thinner shims and add them to what I already have, however, I would prefer a single thicker shim.

Ken Cemo

[Blainefab]

Alan,

I am on Strano springs (550lb front) for now, but if I lower my rear roll center are any of these rear springs you have for sale a good match? Seemingly your selections are probably too stiff. What you think?

-Brent C

You'll want 250-350# in the rear, 11" pigtails with the LT1 perches. Larry got the only set that I had that would work for you. I do have several sets of LT1 rear upper perches left. $40/pair

[Blainefab]

Alan- Do you have any rear spring shims for sale? I need to shim up both sides approx 3/4" to 7/8" on my LT1 car. I could use thinner shims and add them to what I already have, however, I would prefer a single thicker shim.

Ken Cemo

Ken - I make the rear spring shims to order, in any thickness. They are attached to the top of the LT1 perches. If you already have the perches, I'll make a single spacer to your spec, with holes drilled and countersunk. You'll just need to drill 3 holes into the top of your perch, I'll supply self tapping screws.

They end up looking like this:

(IMG:http://blainefab.com/projects/bfpics/IMG_0204.JPG)

[Blainefab]

Time for the fall bump, and I found another pair of used springs - Eibach 0800.250.1200 - yes that's 1200# x 8" x 2.5" ID. $80/pair + $12 shipping via USPS Priority Mail.

(IMG:http://blainefab.com/projects/2016-08-16/1-001.JPG)

I also still have the 14" long 150# and 175# springs, and the rear street springs from posts 1 and 2 of this thread.