![]() |
|
![]() ![]() |
![]() |
![]()
Post
#1
|
|
FRRAX Owner/Admin ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Group: Admin Posts: 15,432 Joined: 13-February 04 From: Ohio Member No.: 196 ![]() |
I bought a brand new FAST XFI 2.0 system last year for my Corvette project. I also picked up a wiring harness for a TPI Chevrolet engine (also the same part number for a 302/5.0 liter EFI Ford engine from an 85 (automatic) to '93 (possibly later than that) 5.0 liter EFI engine. I picked up all new sensors (TPS, IAC, MAP, IAT) and an assortment of harness parts (Analog input harness, XFI quick tune calibration selector switch, "switching output wiring harness", (2) XFI connector kits for the Fan, fuel pump and knock sensor inputs, a new GM knock sensor module (ESC module) and matching knock sensor, the injector harness for SBC/BBC/LT1/Chrysler (except new hemi 5.7 and 6.1) and I forget what else.
I've never had power on this system. I plugged part of the harness in (planning to do a test run with it laying on the windshield) and never finished that part. So, it's truly brand new. I have the main boxes and most of the smaller parts boxes. $2,000 shipped (48 states) trackbird (at) gmail dot com I have the following (totaling $2520.09): http://www.fuelairspark.com/fas/can-termin...sistor-sethtml/ http://www.fuelairspark.com/fas/can-interconnect-cablehtml/ http://www.fuelairspark.com/fas/xfitm-qwik...switch-kithtml/ http://www.fuelairspark.com/fas/xfitm-igni...ses-gm-heihtml/ (modified to fit the Corvette large cap electronic controlled HEI ignition) http://www.fuelairspark.com/fas/xfitm-fuel...-5-7l-6-1lhtml/ http://www.fuelairspark.com/fas/analog-input-harnesshtml/ http://www.fuelairspark.com/fas/xfi-2-0tm-ecuhtml/ http://www.fuelairspark.com/fas/xfitm-conn...l-pump-kithtml/ http://www.fuelairspark.com/fas/switching-...r-directlyhtml/ http://www.fuelairspark.com/fas/vss-auxili...ng-harnesshtml/ http://www.fuelairspark.com/fas/xfitm-main...-universalhtml/ http://www.fuelairspark.com/fas/gm-sensor-...ap-14-5psihtml/ |
|
|
![]()
Post
#2
|
|
FRRAX Owner/Admin ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Group: Admin Posts: 15,432 Joined: 13-February 04 From: Ohio Member No.: 196 ![]() |
$1895 shipped (48 states). That's about $850 off what I paid for it (with the knock sensor module, knock sensor, wiring harness, parts and freight for all of it).
|
|
|
![]()
Post
#3
|
|
Member ![]() Group: Advanced Members Posts: 239 Joined: 18-July 04 From: Columbus, Ohio Member No.: 410 ![]() |
Throwing in the towel?
|
|
|
![]()
Post
#4
|
|
FRRAX Owner/Admin ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Group: Admin Posts: 15,432 Joined: 13-February 04 From: Ohio Member No.: 196 ![]() |
|
|
|
![]() ![]() |
Lo-Fi Version | Time is now: 2nd May 2025 - 01:53 AM |