[rmackintosh]

Hey Everyone!

Long time, no see!

I have had my "only used once" full floater setup sitting in storage for a long time. Recently, I sent it to my gear shop to have it given the once over. He checked it all out and it was good but for a slightly bent axle tube. We had had them cambered before and took it to a race shop to have the axles put back to spec.

Here are a few photos of the setup as it sits now:

(IMG:https://farm9.staticflickr.com/8836/28728241535_3d3cd6e801_m.jpg)

(IMG:https://farm9.staticflickr.com/8060/28728240855_5842c0a790_m.jpg)

I can get more if there is interest.

Here is the setup:

• Speedway Engineering Full Floater Housing
• Mark Williams Aluminum Center Section w/3.55 rear gears
• 31 Spline Axles
• Wilwood SuperLite Brake Caliper/Rotor setup to match to Stoptech ST60s in Front
• DPI Platinum Trac Differential

The whole setup had 4th Gen Camaro brackets put on it to work with the Unbalanced Engineering Decoupled Torque Arm setup.

The housing was approx. $900 new, the center sections start at $2000 on Mark Williams site, and the brakes were around $1000 or so, and then axles, seals, etc...all adds up. Over $5000 in it new....

I am looking at a FIRE SALE on this as it has sat for a long time and needs a home.

Was looking at $2000 OBO.

Hoping to sell local in Norcal so I can deliver.

Thanks

Let me know

Randy Mackintosh

rmackintosh at comcast.net

This post has been edited by rmackintosh: Aug 2 2016, 08:49 PM